/

BBM-02 Series - Bus Bar Module Current Sensors

Bus Bar current sensor modules enable measurement of currents in the large f-bandwidth of DC to 200kHz without an impact of external magnetic fields.

  • For DC & AC currents up to 5kA with frequency bandwidth DC – 200kHz
  • Small size, very compact and low profile mechanical package
  • Easy to assemble structure: its installation does not require an interrupt of the circuit
  • Custom design bus bar geometries possible
  • +5Vdc unipolar power supply
  • High level differential linear signal output-BBM-01

Price range: CHF 55 – 70

The Senis Bus Bar Current Sensor module BBM-02 is a bus-bar DC and AC current transducer. Attached to a rectangular cross-section current bus-bar, the BBM-02 enables contactless measurement of DC and AC currents in the bus-bar. The BBM-02 incorporates two Hall-effect magnetic field sensors, which shall be located at two opposite sides of a bus bar. The sensors generate an output voltage, which is proportional to the magnetic field produced by the electrical current currying the bus-bar. The signals generated in the two sensors by external magnetic fields are mutually cancelled. The BBM-02 does not contain any ferromagnetic part, so it has no hysteresis. The offset and sensitivity of the BBM-02 are in-factory calibrated.

The current sensitivity and the dynamic response of a current transducer based on the BBM-02 depend on the bus-bar geometry and the position of the BBM-02 relative to the bus bar.

Features

  • For DC & AC currents with frequency bandwidth DC – 200kHz
  • Small size, very compact and low profile mechanical package
  • Easy to assemble structure: its installation does not require an interrupt of the circuit
  • Custom design bus bar geometries possible
  • +5Vdc unipolar power supply
  • High level differential linear signal output
  • Signal output electrically isolated from primary Bus Bar
  • Clean recovery from very high overload

Personal Information

Please Choose Between